Simply select the existing assembly split, click the Assembly Split icon, and then select a face. Only the Assembly Features Definition dialogue box opens, allowing you to select the relevant elements.
You can construct assembly models in CATIA using one of two methods. The bottom-up design approach is the first, while the top-down design approach is the second. The next sections go over both of these design techniques. For building assembly models, bottom-up assembly is the preferred method.
Using the Sketch Plane to Cut the Part
From the geometry, double-click Sketch. 2.
Move the drawing around to see the entire part.
From the Visualization toolbar, select Cut Part by Sketch Plane.
Split is a CATIA feature that allows you to take off one part and replace it with another. It is possible to cut off a line or a curve using a point, a curve, or a surface when using split. Using a curve, line, or surface to split a surface.
Learner's Ratings
4.7
Overall Rating
76%
18%
3%
1%
2%
Reviews
K
KULWANT SINGH
5
sir from where i got this step file
and sir this course is very helpful . sir if you will upload FEA AND CFD course that will also helps lots of peoples
S
Srikanth Reddy Y
5
Thank you
Ashok kumar
5
Sir,
3D experience CATIA V6 Piping course provide
V
Vaibhav Prasad
5
Its dammm too good and detailed with every lecture and exampled
V
Vaibhav Prasad
5
Seriously saying i loved the course , i learned it for free and i have completed up to 70% course and i am now dam good in designing . Thank you soo much
E
Er. Krishna Mandal
5
sir how to start my career in design engineer please sagest
sir.
P
Prathmesh Kashid
5
sir thread are not see after proccess
S
Sadanand Sanjay Bondre
5
one of the best teaching i am preparing for automotive plastic domain its helps me a lot plz cover the ugnx software also
P
Parag Borse
4
Hello sir, how to move shaft inside of hollow part with distance please guide
Share a personalized message with your friends.