The Shaft and Groove Command creates a groove on a surface, which is used for the insertion of other parts. The depth of the groove can be specified by using the Depth parameter. The width of the groove can also be specified by using the Width parameter.
The advantage of using Shaft and Groove command is that it allows you to create grooves with more than one depth. It also provides you with the option to create an open or closed groove.
The Shaft and Groove command is used to create a groove on the surface of a solid body. This is typically done to allow for mating with another solid body.
Grooves are revolving features that take material away from other features. This challenge demonstrates how to make a groove, or how to rotate a profile around an axis (or construction line).
Learner's Ratings
4.7
Overall Rating
76%
18%
3%
1%
2%
Reviews
K
KULWANT SINGH
5
sir from where i got this step file
and sir this course is very helpful . sir if you will upload FEA AND CFD course that will also helps lots of peoples
S
Srikanth Reddy Y
5
Thank you
Ashok kumar
5
Sir,
3D experience CATIA V6 Piping course provide
V
Vaibhav Prasad
5
Its dammm too good and detailed with every lecture and exampled
V
Vaibhav Prasad
5
Seriously saying i loved the course , i learned it for free and i have completed up to 70% course and i am now dam good in designing . Thank you soo much
E
Er. Krishna Mandal
5
sir how to start my career in design engineer please sagest
sir.
P
Prathmesh Kashid
5
sir thread are not see after proccess
S
Sadanand Sanjay Bondre
5
one of the best teaching i am preparing for automotive plastic domain its helps me a lot plz cover the ugnx software also
P
Parag Borse
4
Hello sir, how to move shaft inside of hollow part with distance please guide
Share a personalized message with your friends.