Select the surface by clicking Local healing in the Repair Geometry toolbar. Select the two problematic edges by clicking No selection in the Edges To Heal box. and a Tangency Objective that is lower than the default tangency Select All in the Shown Solution(s) field on the Visualization tab.
Select Surface with Multi-sections. The dialogue box Multi-sections Surface Definition appears.
Choose at least two planar section curves. In point, the curves must be continuous.
Select the Preview option.
Select one or more guiding curves if necessary.
To construct the multi-sections surface, click OK.
Learner's Ratings
4.7
Overall Rating
76%
18%
3%
1%
2%
Reviews
K
KULWANT SINGH
5
sir from where i got this step file
and sir this course is very helpful . sir if you will upload FEA AND CFD course that will also helps lots of peoples
S
Srikanth Reddy Y
5
Thank you
Ashok kumar
5
Sir,
3D experience CATIA V6 Piping course provide
V
Vaibhav Prasad
5
Its dammm too good and detailed with every lecture and exampled
V
Vaibhav Prasad
5
Seriously saying i loved the course , i learned it for free and i have completed up to 70% course and i am now dam good in designing . Thank you soo much
E
Er. Krishna Mandal
5
sir how to start my career in design engineer please sagest
sir.
P
Prathmesh Kashid
5
sir thread are not see after proccess
S
Sadanand Sanjay Bondre
5
one of the best teaching i am preparing for automotive plastic domain its helps me a lot plz cover the ugnx software also
P
Parag Borse
4
Hello sir, how to move shaft inside of hollow part with distance please guide
Share a personalized message with your friends.