Select Extract. The dialogue box for Extract Definition appears.
Choose an element's edge or face to work with. The highlighted element has been chosen.
Select the type of propagation:
To see more possibilities, click Show parameters>>.
To extract the piece, click OK.
In a plane parallel to the front of the controller, draw the side profile of the buttons. If the buttons are mirror images of one another, only draw one.
To define the button width, pad the sketch.
round off the button ends with fillets
To build the second button, mirror the pad and fillets.
Learner's Ratings
4.7
Overall Rating
76%
18%
3%
1%
2%
Reviews
K
KULWANT SINGH
5
sir from where i got this step file
and sir this course is very helpful . sir if you will upload FEA AND CFD course that will also helps lots of peoples
S
Srikanth Reddy Y
5
Thank you
Ashok kumar
5
Sir,
3D experience CATIA V6 Piping course provide
V
Vaibhav Prasad
5
Its dammm too good and detailed with every lecture and exampled
V
Vaibhav Prasad
5
Seriously saying i loved the course , i learned it for free and i have completed up to 70% course and i am now dam good in designing . Thank you soo much
E
Er. Krishna Mandal
5
sir how to start my career in design engineer please sagest
sir.
P
Prathmesh Kashid
5
sir thread are not see after proccess
S
Sadanand Sanjay Bondre
5
one of the best teaching i am preparing for automotive plastic domain its helps me a lot plz cover the ugnx software also
P
Parag Borse
4
Hello sir, how to move shaft inside of hollow part with distance please guide
Share a personalized message with your friends.