This job demonstrates how to build a wall using extrusion. You can extrude sketches made out of lines, circles, line projections, and circle projections. You can also extrude any type of profile that has been opened. The Sheet Metal parameters must have been set.
Extrude Feature Information You can only do a solid cut, surface, or surface trim in Assembly mode. To use the Extrude tool, go to Model > Extrude and generate an extrusion drawing.
A revolve can be created by rotating an open or closed profile. A specified sweep angle around an axis guides the rotation. This exercise demonstrates how to define a revolve. Open the CATPart document Revolve.
Learner's Ratings
4.7
Overall Rating
76%
18%
3%
1%
2%
Reviews
K
KULWANT SINGH
5
sir from where i got this step file
and sir this course is very helpful . sir if you will upload FEA AND CFD course that will also helps lots of peoples
S
Srikanth Reddy Y
5
Thank you
Ashok kumar
5
Sir,
3D experience CATIA V6 Piping course provide
V
Vaibhav Prasad
5
Its dammm too good and detailed with every lecture and exampled
V
Vaibhav Prasad
5
Seriously saying i loved the course , i learned it for free and i have completed up to 70% course and i am now dam good in designing . Thank you soo much
E
Er. Krishna Mandal
5
sir how to start my career in design engineer please sagest
sir.
P
Prathmesh Kashid
5
sir thread are not see after proccess
S
Sadanand Sanjay Bondre
5
one of the best teaching i am preparing for automotive plastic domain its helps me a lot plz cover the ugnx software also
P
Parag Borse
4
Hello sir, how to move shaft inside of hollow part with distance please guide
Share a personalized message with your friends.